Sign in
 
HomeOnline20132010Other VersionsLibraryForumsGalleryEHLO Blog
TechCenter >
> 
> 
Restrict senders on SMTP

Answered Restrict senders on SMTP

  • Thursday, December 27, 2012 3:16 PM
     
     
    Sign In to Vote
    0

    hi,

    i have created a send connector which allows the user to send email to internet

    however i want certains users, certain DG and certain IP range which should not be allowed to send email to outside

    but they should be ALLOwed to send email within the exchange organization

    Please assist

    Thanks

    Viraj

    Please remember to click “Mark as Answer” on the post that helps you, and to click “Unmark as Answer” if a marked post does not actually answer your question. This can be beneficial to other community members reading the thread.

     

All Replies

  • Thursday, December 27, 2012 4:44 PM
     
     
    Sign In to Vote
    1
    http://exchangepedia.com/2007/07/how-to-prevent-a-user-from-sending-and-receiving-internet-mail.html

    Ed Crowley MVP "There are seldom good technological solutions to behavioral problems."

     
  • Friday, December 28, 2012 11:32 AM
     
     
    Sign In to Vote
    0

    hi Ed,

    how to do it without transport rules is any other mechanism all in the transport rules i cannot set the IP range only for a certain user or a Distrubuted group but how to do it for a certain IP ranges

    is there a mechanism to do it from send or recieve connector.

    Please advice

    Thanks

    Viraj

    Please remember to click “Mark as Answer” on the post that helps you, and to click “Unmark as Answer” if a marked post does not actually answer your question. This can be beneficial to other community members reading the thread.

     
  • Friday, December 28, 2012 11:57 PM
     
     Answered
    Sign In to Vote
    0
    Apparently not.

    Ed Crowley MVP "There are seldom good technological solutions to behavioral problems."

     
  • Monday, December 31, 2012 3:35 AM
    Moderator
     
     
    Sign In to Vote
    0

    Send Connector can setup retristion based on domain level, but not based on user. Your understanding would be appreciated.

    REfer to:

    http://technet.microsoft.com/en-us/library/aa998662(v=exchg.141).aspx

    Fiona Liao
    TechNet Community Support

     
  • Thursday, January 03, 2013 3:21 PM
     
     
    Sign In to Vote
    0

    hi Fiona_Liao and Ed Crowley,

    dont you think this is down side of the Exchange 2010

    which might be or should be taken care in next release exchange 2013

    Please remember to click “Mark as Answer” on the post that helps you, and to click “Unmark as Answer” if a marked post does not actually answer your question. This can be beneficial to other community members reading the thread.