cannot configure directaccess on server 2012 with two adapters
-
Tuesday, January 29, 2013 4:58 PM
I am trying to setup directaccess on server 2012 with two adapters, one connected to the intranet and one connected to the perimeter network. When I select the option "Behind an edge device (with two network adapters)" I get the error message "An external adapter with a valid IP address, IPv6 enabled and without a domain profile cannot be located".
In network and sharing center both adapters are assigned to the domain network. Is there anyway to get this to work? I tried to figure out how to assign one adapter to the domain network profile and one to a private profile but with no luck.
All Replies
-
Wednesday, January 30, 2013 9:52 AM
Hi,
I had this problem in my test network.
It is automatically assigned in network and sharing.
You have routing that is allowing the external adapter to see the domain traffic. Check what rules you have on the default gateway/firewall?
Regards, Rmknight
- Proposed As Answer by rm_knight Friday, February 01, 2013 8:32 AM
-
Thursday, January 31, 2013 8:01 PMI configured the firewall so that the perimeter network adapter could not access the internal network and now one adapter is in the domain profile and the other is in the public profile, so the problem is fixed.
-
Monday, February 04, 2013 9:42 PM
Hi Craig
How did you map the Network adapters to the profiles? I found no information about how to do this.
-
Tuesday, February 05, 2013 9:20 AM
Hi,
There no way of doing this in the OS. it has to be done at a network level.
Make sure there is no routing between the external network and the Corp network.
Regards, Rmknight
-
Tuesday, February 05, 2013 2:20 PMI modified the windows firewall so that the adapter on the perimeter network had no access to the internal network, which caused that adapter to have a public profile.
.png)
