What should be done in ONE task sequence to make OS installed into correct partition?
-
Saturday, October 06, 2012 11:36 AM
There are two situations below.Please tell me how to set the task sequence to make the OS deployment run correctly so that the OS can be installed into the suitable disk partition.
Situation 1 : An OLD OS had been installed in the partition 1 of disk 1, now I want to reinstall an OS in the partition 1 of disk 1.
Situation 2: An OLD OS (Win 7)had been installed in the partition 2 of disk 1, while the partition 1 of disk 1 is the system reserved partition with the capacity of 100MB. Now I want to reinstall an OS.
Please tell me what should be done in a very task sequence,so that the 2 situations could be correctly adapted in ONE task sequence.
Hard Disk can not be re-patitioning for all data on the other partitions could not be deleted except the OS partition.
Thanks!
- Edited by Long Bo Saturday, October 06, 2012 12:09 PM
All Replies
-
Sunday, October 07, 2012 1:26 AM
There is a screenshot about this topic.
A computer installed Windows 7 Ultimate x64 with 3 patitions: a system reserved partition of 100MB, a OS partition, 2 data partition, all of them are primary partitions.
Now I attempt to install a Windows 7 Utimate x86 on it.
In MDT,in the Task Sequence of "Windows 7 Utimate x86", I made the setting below:
But after the client computer was deployed OS with the Task Sequence of "Windows 7 Utimate x86", An error screen was displayed.
.png)
