MDT：Why had the PE startup screen been always on the screen，and could not go on?
-
Saturday, September 29, 2012 2:21 AM
I had deleted all the partitions of hard disk. And I had completely updated the deployment share, reloaded the litetouch PE into WDS's boot image node.
Why had the PE startup screen been always on the screen，and cannot go on?
what's wrong?
I had done a further test： booting from “Lite Touch PE (x64) ” was OK. booting from “Lite Touch PE (x86) ” was bad still...
Puzzled！
All Replies
-
Saturday, September 29, 2012 7:26 AM
-
Sunday, September 30, 2012 3:00 AM
I had doone a test again.
I had no drivers injected into both x64 and x86 PE，then I regenerated boot images.
Client computer could normally start up from x86 boot image again. How strainge!
Before the issue came out, everything was OK with drivers being injected into PE.
This issue came with a abnormal manual abort by me in the Lite Touch Windows PE x86 when choosing "Keyboard Layout" “Time Zone”,etc.
-
Sunday, October 07, 2012 3:22 PM
Fully renewing all the mass storage drivers in Out-of-Box Drivers, issue had gone away.
Maybe the problem came out because of some mass storage drivers was bad.
.png)
