SBS 2011 DNS listen addresses problem (always reset "Listen on: all IP addresses" when reboot server)
Monday, June 18, 2012 11:27 PM
server: SBS 2011 Standard, SP1. 2 nic, but the second is disabled. No have hyper-v role, but was, just i uninstalled some days ago.
I set the correct listen addresses in dns manager properties. But when i restart the server, this listen addresses resetting, and always set "Listen on: all IP addresses".
Therefore i have 404, 407, 408, 4015 events in dns event log, and stop some services (randomly) when server restarted.
I try run fix network tool, from sbs console, but no change.
The correct listen addresses:
Monday, June 18, 2012 11:28 PM
dns event logs:
Wednesday, June 20, 2012 6:04 AMModerator
Do you have a second NIC on the server? Please notice that two NIC is not supported since SBS2008:
SBS 2008: Supported Networking Topology
TechNet Community Support
Wednesday, June 20, 2012 6:54 AMYes, I have second nic, but this is disabled.
I observe silently: Otherwise, i have more sbs 2011 servers, where i use 2 nics (the second is hyper-v) and no problem, but now, this is not intresting.
Now i use only one nic, but a few days ago, installed and then uninstalled hyper-v (use second nic, for hyper-v) for some reason.
I have event id 410, and this reset the dns interface listen addresses, and this set use all ip addresses.
Wednesday, June 20, 2012 7:57 AM
I agree with Sean Zhu, 2 NICs are not supported in SBS 2011.
For SBS queries, it is better to discuss here.
Wednesday, June 20, 2012 9:00 AMOk, i agree, but there is a solution to the problem?
Please move this thread to the SBS forums. Thanks
Monday, June 25, 2012 9:32 AM
Not sure if installing/uninstalling Hyper-V on SBS2011 may cause such issue. Not sure if two nic may cause such issue, either. Both of them are un-supported scenario on SBS.
Maybe check this out
Monday, June 25, 2012 9:57 AM
Maybe check this out
- Edited by h-zsolt Monday, June 25, 2012 10:00 AM
Monday, June 25, 2012 9:29 PM
You _must_ disable the 2nd NIC at the physical level (or remove it if it is a card).
You _must not_ enable the HyperV role on SBS. It breaks SBS.