Clients not showing up in Multicast Transmissions
-
Thursday, March 01, 2012 7:29 PM
Unicasting images works great, but after following steps to create a Multicast Transmission, clients still unicasts like it usually does.
I was expecting once I configured a Multicast Transimission that clients would wait (Scheduled, not Auto). I also do not see any clients listed on the server's WDS MMC.
Per a colleuge of mine, IGMP snooping looks to be on (we have Cisco switches, and they are on by default according to this:
We're at a loss.
All Replies
-
Thursday, March 01, 2012 8:50 PMBalancing load in your LAN ??
Edwin Garzon
-
Thursday, March 01, 2012 10:46 PMI'm not sure what you're asking, sorry.
-
Friday, March 02, 2012 7:04 AMModerator
Hi,
At first, please verify that you have met the prerequisites to deploy multicast deployments according to the link below:
Title: Performing Multicast Deployments
URL: http://technet.microsoft.com/en-us/library/dd637994(v=ws.10).aspxAt the same time, you need to pay attention to the known issues and procedures to create a multicast transmission based on the article above.
If all the things were done well according to the article above, please run the following command in the command prompt with the evaluated right on the WDS server:
WDSUTIL /Get-MulticastTransmission /Show-clients
Then post back the result here to get further analysis.
Regards,
James
James Xiong
TechNet Community Support
- Marked As Answer by James XiongModerator Tuesday, March 06, 2012 9:37 AM
-
Tuesday, March 06, 2012 9:37 AMModerator
Hi,
Any Update?
James
James Xiong
TechNet Community Support
.png)
