로그인
 
홈라이브러리학습다운로드지원커뮤니티포럼
Resources for IT Professionals >
> 
> 
Can't upgrade from Win2008R2 Ent to the Windows Server 8 Beta - "cannot find a location to store temporary installation files"

답변됨 Can't upgrade from Win2008R2 Ent to the Windows Server 8 Beta - "cannot find a location to store temporary installation files"

  • 2012년 5월 5일 토요일 오전 1:10
     
     
    로그인하여 투표
    0

    I'm getting the following error message when I try and run setup:

    Windows Setup cannot find a location to store temporary installation files. To install Windows, make sure that a partition on your boot disk has at least 1237 megabytes (MB) of free space.

    Error code: 0x80070490

    I have penty of space (100GB on my C drive and 700GB on my D drive). My partition configuration is a little unusual (two disks - the C drive is a partition on one and the D drive is a software RAID/striped disk that spans both disks).

    My tmp/temp environment variables were set to point to the D drive. I read a forum post that indicated this could be a problem so I changed them back to C: and still ahve the same issue.

    I ran SFC /scannow and it reports no integrity violations.

    I'm not sure how to continue...

     

모든 응답

  • 2012년 5월 5일 토요일 오전 4:34
     
     답변됨
    로그인하여 투표
    0
    Hi,

    Try the following steps:

    1. Backup your important data.
    2. Switch SATA port with disk 0 and disk 1, or configure computer to boot from disk 1 in BIOS.
    3. Boot the computer with Windows Server 2008 R2 installation disk, click “Repair your computer” in the following wizard, then launch “Command Prompt”.

    4. In Command Prompt, type “d:\windows\system32\bcdboot d:\windows /s d:”, d:\ is the disk where your system installed, adjust it accordingly.
    5. Boot the computer from disk 1
    6. Try to perform a upgrade to see whether you get the same issue.
    7. You can remove the original 100MB’s reserved partition on disk 0.

    • 편집됨 Zephyrhu 2012년 5월 5일 토요일 오전 4:35
    • 답변으로 표시됨 Vincent HuModerator 2012년 5월 9일 수요일 오전 5:45
    •  
     
  • 2012년 5월 9일 수요일 오후 8:29
     
     
    로그인하여 투표
    0

    Hello,

    Do you by chance have the setup log files from the panther folder?

    If so can you make them available for download?

    Thanks, Darrell Gorter [MSFT] This posting is provided "AS IS" with no warranties, and confers no rights. VAMT - Volume Activation Management Tool - Download link http://www.microsoft.com/downloads/details.aspx?FamilyID=ec7156d2-2864-49ee-bfcb-777b898ad582&displaylang=en

     
  • 2012년 5월 11일 금요일 오후 9:38
     
     
    로그인하여 투표
    0

    Zeph,

    I switched the boot drive order in the BIOS and booted from 2008R2 media. It wasn't able to do a repair because it was unable to detect the installation. :(

     
  • 2012년 5월 11일 금요일 오후 9:43
     
     
    로그인하여 투표
    0

    Darrell,

    It looks like these logs were from the original 2008R2 installation. I assume that is what you were looking for? I have zipped my entire c:\windows\panther directory and have uploaded it to: http://media.wgaw.org/temp/panther.zip

    I'm not sure how my partition table ended up like this, but it feels like the root of my problem is a non-vanilla configuration. I've decided that rather than wrestling w/ the upgrade process that I'm going to just back up my data, wipe my partitions clean and set everything up again.

    Thank you both for your assistance!