none
Unified remote access using teredo

    Question

  • I have it working via HTTPS but cannot seem to get Teredo working.  I am a little confused on the dual IP requirement.  I have assigned dual incremental IP addresses.  Do I need them both assigned to external cards or one on the external and one a NAT'd card?

    Thanks

    Dave

    Wednesday, February 13, 2013 3:06 PM

Answers

All replies

  • Hi,

    Is your DA server deployed behind NAT? if so, you can only use IPHTTPS.

    The two consecutive non-RFC1918 IP-addresses should be assigned to the external interface.
    Other than that you should be able to follow the same steps that you did when deploying it without Teredo.


    Jonas Blom | Relevo AB | http://blog.nrpt.se

    Wednesday, February 13, 2013 5:51 PM
  • The two IP addresses I have are not behind the NAT.  Do they have to be on two separate interfaces?

    Thanks

    Dave

    Wednesday, February 13, 2013 6:03 PM
  • No, they should be configured on the same interface/nic.

    If you look at a standard DirectAccess setup based on Forefront UAG you will see the steps you should follow.
    (A 2-nic Edge setup with Windows Server 2012 follows the standard setup that were used with Forefront UAG)


    Jonas Blom | Relevo AB | http://blog.nrpt.se

    Wednesday, February 13, 2013 7:04 PM