none
c00002e2 Directory Services could not start because

    General discussion

  • hello,

    i have a hyper-v server and i have a guest server that have DC after i resterat it it's give me:

    STOP: c00002e2 Directory Services could not start because of the following error: A device attached to the system is not functioning. - Error Status: 0xc0000001

    i don't have a backup , i tried to statrup using adrm and check ntds files log files and it's on c drive.

    it there any solution to get the users informations ?

    the server have only hard drive.

    so whare is the problem ?

    thanks.

     

    Thursday, August 11, 2011 9:24 AM

All replies

  • Hello,

    please see this similar thread: http://social.technet.microsoft.com/Forums/en-US/winservergen/thread/7ff839c3-5fee-4217-af57-97b0106ef3af


    Best regards Meinolf Weber Disclaimer: This posting is provided "AS IS" with no warranties or guarantees , and confers no rights.
    Thursday, August 11, 2011 10:41 AM
  • Have you seen the following?
    http://techblog.mirabito.net.au/?p=160

    --
    Paul Bergson
    MVP - Directory Services
    MCITP: Enterprise Administrator
    MCTS, MCT, MCSE, MCSA, Security+, BS CSci
    2008, Vista, 2003, 2000 (Early Achiever), NT4
    http://www.pbbergs.com    Twitter @pbbergs
    http://blogs.dirteam.com/blogs/paulbergson

    Please no e-mails, any questions should be posted in the NewsGroup. This posting is provided "AS IS" with no warranties, and confers no rights.

    Thursday, August 11, 2011 12:10 PM
  • Hi,

     

    Any progress on this issue? After boot into directory services restore mode, please create a temp folder, then moved all the log files from the NTDS folder into the temp folder to check the results. Please check the event Log for more detailed information. Also, please check whether all the hardware drivers are updated and check Raid drives are updated.

     

    Thanks.

    Nina


    Please remember to click “Mark as Answer” on the post that helps you, and to click “Unmark as Answer” if a marked post does not actually answer your question. This can be beneficial to other community members reading the thread.
    Tuesday, August 16, 2011 10:01 AM
    Moderator