none
How to add a ipv6 prefix boundary in sccm for Direct Access RRS feed

  • Question

  • Does anyone know how to add a ipv6 prefix for a sccm 2012 boundary?   For one, I'm not sure which prefix I should add.   I tried adding a couple prefix ipv6 addresses I seen on the DirectAccess gpo that is autocreated but sccm says invalid.  For some reason SCCM adds a bunch of zeros after what I put.   

    Any help is appreciated.


    Thanks


    • Edited by CSMatMan Wednesday, May 7, 2014 5:44 PM
    Wednesday, May 7, 2014 5:43 PM

Answers

  • I opened the sccm console and looked for my test computer.  I right clicked the device and did properties.   It then showed all the ipv6 prefixes for under discovery data.   Did all the work for me.   Added those and now my software will download and install from software center.

    • Marked as answer by CSMatMan Wednesday, May 7, 2014 6:55 PM
    Wednesday, May 7, 2014 6:55 PM