locked
UDI and USMT Restore from USB RRS feed

  • Question

  • This seems like a simple solution but for the life of me I can't figure it out despite hours of trial and error and documentation/internet research.  Any help would be greatly appreciated.

    I have created a UDI driven SCCM 1608 task sequence to perform a USMT capture to either a network share or USB drive using the UDI Replace template.  The task sequence is run from the Software Center within Windows (no reboot to WinPE).  I created a similar UDI driven task sequence using the UDI New Computer template to perform a USMT restore.  This task sequence is also run from the Software Center in Windows on the new computer.  The problem is that I cannot find a way to have the user select between the USB and Network restore options. 

    The USB and Network restore options are grayed out when I run the UDI/USMT restore task sequence.  I have locked the ‘No Data’ and ‘Local’ restore options in the UDI New Computer template (so I expect those to be grayed out) but the USB and Network restore options are unlocked.  See attached screen shots for details.

    Can anyone point me in the right direction on how to make both the USB and Network restore options available during the UDI/USMT restore task sequence?

    MDT 2012 Update 2 – UDI/USMT Capture (Replace) Configuration

    Note: Successfully able to select “USB” during UDI/USMT capture task sequence as seen above

    MDT 2012 Update 2 – UDI/USMT Restore (New Computer) Configuration

    Problem: Cannot select “USB” device during UDI/USMT restore task sequence as seen above

    Again, any help or guidance would be greatly appreciated.

    Regards,

    JJ

    Sunday, October 30, 2016 10:51 PM