locked
I can't get an emachine recovery disc made. RRS feed

  • Question

  • I have a model ET1331G emachine desktop. It has a 1.6 GHZ processer,4.00GB with 3.75 useable,64-bit operating system. It is a windows 7 operating system.  I reinstalled my PC to factory defaults as when it was new. I am trying to create factory recovery discs but when I start the program nothing happens. Anybody have any suggestions for this non PC smart guy?
    Sunday, August 26, 2012 7:19 PM

Answers

  • Hi,

    Most manufacturers offer a recovery disk creation tool where you burn your own recovery disks. If that application does not work, then you must report this to the manufacturer who can assist. Often they can provide a copy of the disks for a small fee if it turns out to be a problem with the PC.

    Martin


    If you find my information useful, please rate it. :-)

    • Proposed as answer by Martin G. Evans Monday, August 27, 2012 1:29 AM
    • Marked as answer by Vik200084 Monday, August 27, 2012 12:00 PM
    • Unmarked as answer by Vik200084 Monday, August 27, 2012 12:00 PM
    • Marked as answer by Vik200084 Monday, August 27, 2012 12:00 PM
    Monday, August 27, 2012 1:29 AM

All replies

  • Hi,

    Most manufacturers offer a recovery disk creation tool where you burn your own recovery disks. If that application does not work, then you must report this to the manufacturer who can assist. Often they can provide a copy of the disks for a small fee if it turns out to be a problem with the PC.

    Martin


    If you find my information useful, please rate it. :-)

    • Proposed as answer by Martin G. Evans Monday, August 27, 2012 1:29 AM
    • Marked as answer by Vik200084 Monday, August 27, 2012 12:00 PM
    • Unmarked as answer by Vik200084 Monday, August 27, 2012 12:00 PM
    • Marked as answer by Vik200084 Monday, August 27, 2012 12:00 PM
    Monday, August 27, 2012 1:29 AM
  • Thank you Martin G. Evens !!!  I will contact the manufacturers. I hope I gave you the highest rating possible because your answer was very helpful. Thanks again.


    Nick H. Rollings

    Monday, August 27, 2012 12:04 PM