none
DPM 2012 recovery from multi-cartridge set with a single tape drive RRS feed

All replies

  • Hi,

    There should be an alert telling you to mount the required tape.  Since it's a standalone tape drive, there are no barcodes, so you will need to look at the tape label name in the alert.  If you didn't write the DPM friendly label on the external of the tape cartridge, then just insert a tape in the drive and do an inventory and it will read the tape and display the on-media label, if it isn't the right tape, eject it and put in another until the correct one is mounted, then click on the continue job link in the alert to continue.

    SAMPLE ALERT
    =========

    Affected area: \Backup Using Saved State\MJ-DPM01
    Occurred since: mm/dd.yyyy hh:mm:ss PM
    Description: Recovery Job is paused because the required tape HyperV-LT-1Weekx6-Copy0-00000074 (A11009) is not available in the library Tape Library Sun/StorageTek Library. (ID 3315)
     More information
    Recommended action: 
     Insert the tape with label HyperV-LT-1Weekx6-Copy0-00000074 (A11009) in the library through the I/E port or by unlocking the library door. Click "Continue Job" in the Details section of this alert, if you add the required tape without using the Add tape (I/E port) or Unlock Door actions on the Library tab in the Management task area.
     Continue job...
    Resolution: To dismiss the alert, click below
     Inactivate


    Please remember to click “Mark as Answer” on the post that helps you, and to click “Unmark as Answer” if a marked post does not actually answer your question. This can be beneficial to other community members reading the thread. Regards, Mike J. [MSFT] This posting is provided "AS IS" with no warranties, and confers no rights.

    Friday, April 12, 2013 8:45 PM
    Moderator