none
UDI Wizard - "No supported NTFS volumes found" RRS feed

  • Question

  • I am PXE booting a VMware virtual machine in order to run a MDT-integrated ConfigMgr 2012 R2 task sequence. . .PXE boot works fine and the task sequence starts without issue.  It does an initial partition and format of the disk and then launches the UDI Wizard.   On the Volume page of the wizard, though, no volumes are available for selecting as the target drive and there is an error stating "No Supported NTFS volumes found."
     
    Diskpart from WinPE launches fine and shows volumes are there.  SMSTS.log, bdd.log, and osdsetupwizard.log do not show anything obvious as a cause for the issue.
     
    If the disk is accessible from WinPE via standard means (TS formats drive OK and I can see volumes from Diskpart), but not from the UDI wizard, what should I look at? Has anyone experienced this?
     
    Thanks,
     
    Jeff
    Thursday, November 5, 2015 4:32 PM

Answers

  • This was ultimately a simple fix. . .the hard drive size was too small. . .increased the disk size to 60GB and it worked without issue.

    Jeff

    • Marked as answer by Jeff Poling Thursday, November 5, 2015 7:12 PM
    Thursday, November 5, 2015 7:12 PM