locked
SCCM 2012 SP1 - CU3 - Create Software Update Catalog RRS feed

  • Question

  • I just built a new SCCM 2012 SP1 lab and when I try to install CU3 the setup goes fine until I get to the part where the wizard says "Create Software Update Catalog" and then it failed with an error. If I try to re-run the CU3 update the wizard skips the parts that were already updated and goes straight to the same part and fails.

    I have been doing web searches all week and have found nothing to address this. I'm sure it is a permission issue, but I don't know where to look or what to change.

    Any assistance is greatly appreciated - thanks!

    Saturday, February 22, 2014 2:39 PM

Answers

  • As you can see in the title bar of the dialog box, I am at 2012 SP1.

    As an update, it turns out that it was a botched update install.  I uninstalled, rebooted and then reinstalled and I was good to go.

    • Proposed as answer by DonPick Friday, February 28, 2014 12:43 PM
    • Marked as answer by MRMorris1965 Friday, February 28, 2014 3:40 PM
    Thursday, February 27, 2014 10:52 PM

All replies