none
MIM PAM - Service and Portal Install Error RRS feed

  • Question

  • Guys,

    I'm having an issue deploying MIM Service and Portal. 

    I have downloaded the MIM CTP from the Microsoft Connect and following the MIM CTP test lab guide for PAM. 

    I'm on page 25/26 trying to launch the Service and Portal msi to install. When I launch the setup as the 
    administrator I get the following error.


    When I enabled msiexec logs, the only error I see is shown below. Any ideas?

    Any Ideas appreciate...

    Monday, November 17, 2014 8:07 AM

All replies

  • On Mon, 17 Nov 2014 08:07:14 +0000, Sameera_man wrote:

    I'm having an issue deploying MIM Service and Portal. 

    I have downloaded the MIM CTP from the Microsoft Connect and following the MIM CTP test lab guide for PAM. 

    I'm on page 25/26 trying to launch the Service and Portal msi to install. When I launch the setup as the 
    administrator I get the following error.
    <https://social.technet.microsoft.com/Forums/getfile/567822>

    When I enabled msiexec logs, the only error I see is shown below. Any ideas?

    Have you filed a bug on Connect? That is the preferred support method for
    the CTP.


    Paul Adare - FIM CM MVP
    Q. how many hackers does it take to screw in a light bulb?
    A. Huh?...What? Oh, it's dark in here?

    Monday, November 17, 2014 8:44 AM
  • Thanks for the reply Paul.

    I'll raise a bug report. 

    Monday, November 17, 2014 2:30 PM
  • Where did u find MIM install files on Connect? I can only find MIM CM installer.
    Tuesday, November 18, 2014 2:43 AM
  • On Tue, 18 Nov 2014 02:43:17 +0000, D Wind wrote:

    Where did u find MIM install files on Connect? I can only find MIM CM installer.

    Same place.

    https://connect.microsoft.com/site433/Downloads


    Paul Adare - FIM CM MVP
    bash: syntax error near unexpected token `=:)'

    Tuesday, November 18, 2014 3:53 AM
  • yep found them, refreshed the page and it appeared. thx
    Tuesday, November 18, 2014 9:07 AM
  • Make Sure

    • You have installed IIS with the exact roles and features as mentioned in the Document.
    • You have .NET 3.5 installed.
    • You have installed and configured Sharepoint 2013 SP1 Foundation as mentioned in the Document.
    • You have RUN the command "sn -Vr *", Remember, -Vr is case sensitive.

    Rerun the setup a couple of times.



    Regards Furqan Asghar

    Saturday, November 22, 2014 3:03 PM
  • I had the exact same problem until i followed the installation guide  (MIM CTP Test Lab Guide for Privileged Access Management.docx).

    You have to setup the SharePoint site with PowerShell, etc. before running the installer.


    Friday, November 28, 2014 12:44 PM