none
IPAM - DHCP Servers only show one Scope RRS feed

  • Question

  • I have installed IPAM and added my Servers and at first it looked pretty good, though at a second look the DHCP Servers that have Multiple Scopes (Provide IP for multiple Subnets vis DHCH Relay Agents) defined on them, only one of the Scopes Shows up in IPAM.

    One DHCP Server is a 2012 R2, the other is a 2008 R2. IPAM is installed on a 2012R2 Member Server. 

    Thanks!

      Scott<-

    Thursday, September 1, 2016 9:42 PM

Answers

  • Hi,

    1.Please check the selections you have made for viewing first.

    2.You could also view scopes by clicking DNS and DHCP Servers and choosing Server Type = DHCP and View  = Scope Properties.

    3.Also check and see if the scopes are shown in IP Address Blocks when you choose the Current View = IP Address Ranges.

    4.If a scope was recently created on a DHCP server, or the server was recently added, then all data might not yet be gathered. Right-click the server in SERVER INVENTORY and then click Retrieve All Server Data, and be sure to refresh the view using the display pane refresh button or F5.

    5.It may caused by start IP and end IP,please check this similar thread for your reference:

    DHCP Scopes missing from IPAM

    https://social.technet.microsoft.com/Forums/windowsserver/en-US/f42d71bc-072f-4cd8-9938-08b8ac69ba8c/dhcp-scopes-missing-from-ipam?forum=winserveripamdhcpdns

    ________________________________________
    Best Regards,
    Cartman
    Please remember to mark the replies as answers if they help and unmark them if they provide no help. If you have feedback for TechNet Support, contact
    tnmff@microsoft.com.

    Friday, September 2, 2016 1:47 AM

All replies

  • Hi,

    1.Please check the selections you have made for viewing first.

    2.You could also view scopes by clicking DNS and DHCP Servers and choosing Server Type = DHCP and View  = Scope Properties.

    3.Also check and see if the scopes are shown in IP Address Blocks when you choose the Current View = IP Address Ranges.

    4.If a scope was recently created on a DHCP server, or the server was recently added, then all data might not yet be gathered. Right-click the server in SERVER INVENTORY and then click Retrieve All Server Data, and be sure to refresh the view using the display pane refresh button or F5.

    5.It may caused by start IP and end IP,please check this similar thread for your reference:

    DHCP Scopes missing from IPAM

    https://social.technet.microsoft.com/Forums/windowsserver/en-US/f42d71bc-072f-4cd8-9938-08b8ac69ba8c/dhcp-scopes-missing-from-ipam?forum=winserveripamdhcpdns

    ________________________________________
    Best Regards,
    Cartman
    Please remember to mark the replies as answers if they help and unmark them if they provide no help. If you have feedback for TechNet Support, contact
    tnmff@microsoft.com.

    Friday, September 2, 2016 1:47 AM
  • Hi,

    I am checking to see if the problem has been resolved. If there's anything you'd like to know, don't hesitate to ask.

    ________________________________________
    Best Regards,
    Cartman
    Please remember to mark the replies as answers if they help and unmark them if they provide no help. If you have feedback for TechNet Support, contact
    tnmff@microsoft.com.

    Tuesday, September 6, 2016 7:07 AM