none
DHCP mode RRS feed

  • Question

  • Hi everyone we have to DHCP servers they are in the failvoer mode Load balance mode, we need change mode to hot stand by mode, can we change this from IPv4 properties/failover/edit and change mode, Is it enough to make only these changes without any problems?

    System administrator

    Thursday, December 28, 2017 11:30 AM

Answers

  • Hi ,

    As far as I know, you can switch between hot standby and load balance mode if desired, but you can only use one mode at a time with a single DHCP scope.

    Best Regards,

    Candy


    Please remember to mark the replies as answers if they help.
    If you have feedback for TechNet Subscriber Support, contact tnmff@microsoft.com.

    • Marked as answer by Farid Ahmadov Friday, December 29, 2017 7:43 AM
    Friday, December 29, 2017 5:40 AM

All replies

  • Hi ,

    As far as I know, you can switch between hot standby and load balance mode if desired, but you can only use one mode at a time with a single DHCP scope.

    Best Regards,

    Candy


    Please remember to mark the replies as answers if they help.
    If you have feedback for TechNet Subscriber Support, contact tnmff@microsoft.com.

    • Marked as answer by Farid Ahmadov Friday, December 29, 2017 7:43 AM
    Friday, December 29, 2017 5:40 AM
  • tnank you, I changed mode 

    System administrator

    Friday, December 29, 2017 7:44 AM