none
BitLocker Recovery key is not created when added bitlocker recovery command in the MDT task sequence RRS feed

  • Question

  • Hi,

    I am trying to enable bit locker in client machine through MDT task sequence. In client machine every thing work fine and also operating system is encrypting but problem is that no recovery key is created in AD. to check weather there is any issue in the command i manually type the same command which i used in the MDT TS in the command prompt and this time key is created in the AD. I don't know why the same command not creating key in AD and encrypting the device.

    i used following command in the MDT TS

    Tuesday, April 21, 2015 6:19 AM

All replies

  • Why not just use the existing steps in MDT?


    Please remember to click “Mark as Answer” on the post that helps you, and to click “Unmark as Answer” if a marked post does not actually answer your question. This can be beneficial to other community members reading the thread.



    Tuesday, April 21, 2015 7:46 PM
    Moderator
  • Thanks Glander. I tried once again with the above command once again and surprisingly this time it works. I don't know what was the problem. But issue was resolverd.
    Thursday, April 23, 2015 9:40 AM