none
Fast ESP 5.3 sp3 - config server connection error RRS feed

  • Question

  • Hi,

    Recently i have updated my FAST ESP form v5.3sp1 to v5.3sp3.

    After successful updation following error came in Admin GUI:

    "Could not connect to Config Server at host <host.domain.com> port 16005."

    Surprisingly after two 3 cycles of reinstallation of FAST ESP 5.3 SP3 this error vanishes and ESP works fine as expected.

    I am not able to figure out whats happening. Please help. 

     

     

     

    Tuesday, September 28, 2010 7:26 AM

All replies

  • Hi,

    In many cases we've seen this when IP v6 is enabled on Win 2008 or Win 2008R2. Could that be the case here?

    Thanks,

    Kjetil

    • Proposed as answer by Robin Agrawal Wednesday, September 29, 2010 10:09 AM
    Wednesday, September 29, 2010 8:37 AM
  • Thanks Kjetil.

    I have dissabled IPv6 support and then installed, but in this case too after 2nd cycle of installation only that error went away.

    Wednesday, September 29, 2010 9:30 AM
  • It works after restarting the PC.
    Wednesday, September 29, 2010 10:09 AM
  • I'm having the same problem.  I have installed this on a VM and on the host.  I have disabled IPV6 as well and rebooted.  Not sure where to go from here.
    Monday, November 29, 2010 10:44 PM
  • Hi AhlSys,

    Try dissabling IPv6 on vm as well as the host. Then restart both and check. Problem should be resolved:).


    Nitin

    Tuesday, February 7, 2012 7:05 AM