enable teredo in domain RRS feed

  • Question

  • Hi,
    I was trying to enable the teredo client in Vista when joined to a domain.  I gather from reading this is disabled by default when the computer is joined to a domain. 

    I tried netsh interface ipv6 set teredo enterprise client

    and show teredo still displays:

    Type                               enterprise client
    server name                      teredo.ipv6.microsoft.com
    Client Refresh Interval           30 sec
    client port                         unspecified
    state                                 offline
    error                                   client is in managed network

    How do you turn this on?

    CCNA, A+, N+
    Friday, May 29, 2009 8:41 PM


  • Hi,


    Thank you for posting.


    Based on my research, I would like to suggest the following:


    1.    Please refer to the following document and run the command to see if it works:


    Teredo and the PNRP Global Cloud



    Please note the section:

    If it says “Client is in a managed Network” it means teredo has detected that you are in a corperate environment. If that is the case you need to set the Teredo type to Enterprise client “Netsh int ter set state enterpriseclient”.


    2.    Check your firewall with the following Knowledge Base:


    Firewall requirements for coexisting with Teredo



    Hope this helps. Thanks.

    Nicholas Li - MSFT
    Tuesday, June 2, 2009 7:51 AM

All replies