none
VAMT 2.0 error 0x80070054 Storage to process this request is not available. RRS feed

  • Question

  • Hello,

    I'm attempting to gather some information about the activation status of computers on my network using the Volume activation management tool 2.0

    however when I try to update the status of a particular computer I get this error "Storage to process this request is not available."

    has any one run into this before?


    • Edited by hobbs_550 Tuesday, November 10, 2015 5:51 PM
    Tuesday, November 10, 2015 5:23 PM

Answers

  • Turns out this issue was resolved my entering and validating a key in the product Keys section, Which I had not done yet.

    I added the key and was able to get the client to update  and activate :)

    • Marked as answer by hobbs_550 Thursday, November 12, 2015 5:40 PM
    Thursday, November 12, 2015 5:40 PM

All replies

  • Hi,

    What the operation system is it?

    When searching with this error message, it leads to system resource such as disk space or memory. You can test a reboot to see if it is just a temp issue.

    Also the IRPStackSize may cause a similar issue. Here is the explanation and you can try to set it to a larger number to see the result. 

    The IRPStackSize parameter specifies the number of stack locations in I/O request packets (IRPs) that are used by Windows 2000 Server, by Windows Server 2003, and by Windows XP. You may have to increase this number for certain transports, for media access control (MAC) drivers, or for file system drivers. Each stack uses 36 bytes of memory for each receive buffer. This value is set in the following registry subkey:

    HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\LanmanServer\Parameters

    The default value of the IRPStackSize parameter is 15. The range is from 11 (0xb hexadecimal) through 50 (0x32 hexadecimal).

    If the subkey is not present, you can use Registry Editor to add the subkey. To do this, follow these steps:
    Click Start, click Run, type regedit, and then click OK.
    Locate and then click the following registry subkey:
    HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\LanmanServer\Parameters
    Click Edit, point to New, and then click DWORD Value.
    Type IRPStackSize, and then press ENTER to name the value.

    Note: Type IRPStackSize exactly as it is displayed. The value name is case sensitive.
    Click Edit, and then click Modify.
    In the Data Value box, type the value that is appropriate for the network, and then click OK.
    If the problem persists after you complete this procedure, increase the value of IRPStackSize even more.

    Note: On some computers, values from 33 through 38 can cause problems. For information about a hotfix that addresses these problems, click the following article number to visit the article in the Microsoft Knowledge Base:

    924749 Event ID 2021 is logged even though lots of non-paged pool memory is available in Windows Server 2003
    https://support.microsoft.com/en-us/kb/924749

    Please remember to mark the replies as answers if they help and un-mark them if they provide no help. If you have feedback for TechNet Support, contact tnmff@microsoft.com.

    Wednesday, November 11, 2015 6:32 AM
    Moderator
  • Turns out this issue was resolved my entering and validating a key in the product Keys section, Which I had not done yet.

    I added the key and was able to get the client to update  and activate :)

    • Marked as answer by hobbs_550 Thursday, November 12, 2015 5:40 PM
    Thursday, November 12, 2015 5:40 PM