MDT: howto prevent ts from resuming? RRS feed

  • Question

  • Hi,

    I'm testing a depoy on MDT, sometime I need to interrupt the ts and start from scratch. Then I always need to remove the harddisk (vmware) and start all over. There is a tasksequence step which formats the drive but this happens once the specific ts is started.
    How can I make sure the drive(s) is(are) formatted before starting the ts?


    Jan Hoedt

    Tuesday, September 30, 2014 11:32 AM


  • The disk does not need to be formatted before starting the TaskSequence, the Task Sequence can run with Disk(0) in any state.

    Typically, when re-running a Task Sequence over and over, I will make a snapshot of a virtual machine at a specific point (like when it's clean), in order to run the TS in a known state.

    What is the problem?

    Keith Garner - Principal Consultant [owner] -

    Thursday, October 2, 2014 12:14 AM