Upgrading to Exchange 2013 This Summer - What to Change in FIM? RRS feed

  • Question

  • We are currently using FIM to provision mailboxes and mail contacts in Exchange. We are currently on Exchange 2010 SP3. When we originally set up Exchange interrelation with FIM, we used this information found here:

    We enabled Kerberos and set up FIM to use the load balanced name of our CAS array. 

    When we go to Exchange 2013, what do we need to change on the FIM side?  I know we will need to change the provisioning database, but what else is required?  I notice Exchange 2013 is not available in the drop down menu on the ADMA agent.  I read you just leave that as Exchange 2010.

    Monday, April 28, 2014 11:59 PM

All replies

  • Hi,

    For this upgrade process you need not make many changes into FIM. All you need to do is just follow below link and You will be good to go:

    Rest all settings will be same as Exchange-2010. 

    If My Answer helps you do not forget to check helpful post and If answers your question do not forget to "Mark it as an Answer" Thanks~ Giriraj Singh Bhamu

    Tuesday, April 29, 2014 4:51 PM
  • But the concept of a "CAS Array" goes away in Exchange 2013, so I will have to change something because the name of our CAS array will go away.  The only thing extra we had to do on Exchange 2010 was enable Kerberos on the CAS Array.  Is that enabled by default on Exchange 2013?  If so, it's an easy switch.  We are already on Service Pack 1 with the latest hotfix.
    Wednesday, April 30, 2014 2:34 AM