locked
No IAG forum? RRS feed

  • Question

  • Anyone know if there is an IAG forum around here? After all it is edge security.
    • Moved by Keith Alabaster Thursday, June 25, 2009 5:06 PM MS Request (From:Forefront Edge Security - General)
    Wednesday, July 30, 2008 8:27 PM

Answers

All replies

  • Hi Andy,

    Thanks for asking. Like Rachel posted in another thread they are working on a separate forum for IAG specific questions. In the meantime, soak up the knowledge about ISA, which is part of the IAG 2007 solution. Did you have a specific question about IAG?

    Dan Watson
    Friday, August 1, 2008 1:45 AM
  • Hi Andy,

    Thanks for asking. Like Rachel posted in another thread they are working on a separate forum for IAG specific questions. In the meantime, soak up the knowledge about ISA, which is part of the IAG 2007 solution. Did you have a specific question about IAG?

    Dan Watson
    Friday, August 1, 2008 1:45 AM
  • Hi Andy,

    Thanks for asking. Like Rachel posted in another thread they are working on a separate forum for IAG specific questions. In the meantime, soak up the knowledge about ISA, which is part of the IAG 2007 solution. Did you have a specific question about IAG?

    Dan Watson
    Friday, August 1, 2008 1:46 AM
  • Andywallace1 said:

    Anyone know if there is an IAG forum around here? After all it is edge security.



    Not yet. Rachel says they are working on it. Did you have a specific question?

    Dan Watson
    Friday, August 1, 2008 1:47 AM
  • Not yet. Rachel is working on it. Did you have a specific question?
    Friday, August 1, 2008 1:48 AM
  • Hi Dan

    Yes i did have a quetion. We have recently purchased an IAG appliance however i have discovered that it does not seem to support drive mappings if DFS is in use. eg in iag config when setting up a drive mapping it only allows you to choose a netbios name not a DFS root. Any way around this? I am aware i could use the whale connector but due the problems with the connector i don't want ot go down that route if i can help it.
    Somehow i need to enable full access to youe network drives in order to pursaude our users to make use of IAG rather then a full VPM session through a Cisco concentrator.

    Andy
    Friday, August 1, 2008 7:38 PM
  • Hi,

    There is a new IAG Forums in the following link http://forums.IAGserver.ORG and also new Knowledge Center http://www.IAGserver.ORG

    HTH
    Friday, October 31, 2008 6:41 PM
  • Andy,

    The IAG Forum can be found here. A little late but.... thanks for raising it.
    http://social.technet.microsoft.com/Forums/en-US/forefrontedgeiag/threads

    Thanks
    Keith
    Saturday, June 6, 2009 6:39 AM