none
Surface Pro 3: unable to reimage with MDT 2013 RRS feed

Answers

All replies

  • Solved...it was USB hub, i had changed to following, works flawless.

    Image


    orion

    • Marked as answer by Ultra9.99 Thursday, June 26, 2014 1:41 PM
    Thursday, June 26, 2014 1:41 PM
  • Hi there,

    I am using MDT 2013 on a WDS 2008 R2 and everytime i tried to image the tablet via PXE boot through the Surface Pro 3 ethernet adapter, i get this error:

    Wizard Error:

    A connection to the deployment (my deployment share) could not be made.

    The following network device did not have a driver installed.

    PCI\VEN_11AB&DEV_2B38&SUBSYS_045E0001&REV_00

    Retry: Try again to connect to the deployment share.

    Cancel: Give up, cancelling any in-progress task sequence.

    PLEASE HELP!

    Thursday, October 9, 2014 11:03 PM
  • Hi there,

    I am using MDT 2013 on a WDS 2008 R2 and everytime i tried to image the tablet via PXE boot through the Surface Pro 3 ethernet adapter, i get this error:

    Wizard Error:

    A connection to the deployment (my deployment share) could not be made.

    The following network device did not have a driver installed.

    PCI\VEN_11AB&DEV_2B38&SUBSYS_045E0001&REV_00

    Retry: Try again to connect to the deployment share.

    Cancel: Give up, cancelling any in-progress task sequence.

    PLEASE HELP!


    YOu most likely need to add the microsoft networking adapter to the MDT console, and explicitly add it to the WinPE group. Don't forget to rebuild the deployment share so it regenerates the WinPE iamge.

    Keith Garner - Principal Consultant [owner] - http://DeploymentLive.com

    Saturday, October 11, 2014 12:22 AM
    Moderator
  • this HWid is for Marvell AVASTAR Wireless-AC Network Controller driver .

    As Keith mentioned, you don't have usb network adapter driver in WinPE installed.

    Download two network drivers to winpe from

    http://www.microsoft.com/en-us/download/details.aspx?id=38826

    1.Surface Ethernet Adapter

    2.Surface Gigabit Ethernet Adapter

    should be able to boot....


    orion

    Saturday, October 11, 2014 3:03 AM
  • I have just reimported those drivers to WinPE still the same error.
    Tuesday, October 14, 2014 4:05 PM
  • Did you do a full update of the deployment share?

    Do you have a selection profile for WinPE Drivers? Are the drivers in the correct folder?

    Do a comparison of the PnP ID's for the drivers imported into MDT, and the PNP from WinPE (from above).


    Keith Garner - Principal Consultant [owner] - http://DeploymentLive.com

    Tuesday, October 14, 2014 11:59 PM
    Moderator
  • I bought a Belkin USB2.0 adapter and connected to my Pro 3 while the Pro 3 ethernet adapter is connected as well. So 2 network cables are needed. I pxed boot using the Pro 3 ethernet adapter and deploy the image using the Belkin2.0 adapter. Error didnt come back and deployment was successful. I mean this is a workaround but it works in my environment. The Belkin2.0 drivers are in WinPE and MDT.
    Thursday, October 23, 2014 10:21 PM