none
Console crashes after r2 upgrade RRS feed

  • Question

  • Hi,

    I upgraded to Data Protection Manager 2012 r2 yesterday and I have had a lot more crashes on the remote and local console. Is this a known issue? I have installed rollup 3 as well.

    Any help would be much appreciated.

    Best wishes

    Michael


    Thursday, September 11, 2014 12:34 PM

All replies

  • Hi

    Try repairing the dpm database and fixing the protection groups.

    Does it crash with code 999?


    Hope this helps. Please remember to click “Mark as Answer” on the post that helps you, and to click “Unmark as Answer” if a marked post does not actually answer your question. This can be beneficial to other community members reading the thread.

    Thursday, September 11, 2014 12:41 PM
  • I am moving the server to new hardware tomorrow so the database will move then as well. I will see how it goes. I didn't notice the error code as I just clicked to make it relaunch. I will take note next time.

    Is their a special command to repair the Data Protection Manager database? I could run it on the restored copy on the new hardware.

    Best wishes

    Michael


    Thursday, September 11, 2014 5:18 PM
  • It has just done it again. This is on the primary and not the new hardware. It errored with a 917.

    Friday, September 12, 2014 7:18 PM