IBM devices under uninitialized mode in monitoring RRS feed

  • Question

  • Have added IBM Spectrum devicess in SCOM, the devices, its associated volumes, node and other features has been discovered but the state seems to be in uninitialized state.

    The monitor "Spectrum Virtualize Family Storage Node Unit Monitor" is healthy but the rollup monitor is in uninitialized state.Could anyone guide me in troubleshooting it.

    Thursday, November 9, 2017 10:58 AM

All replies

  • Hey there,

    are you using a MP from IBM? Are those servers?

    How long have you waited?

    Can you please post a coulpe of screenshot to make it easier to grasp.

    Thanks in advance. Regards,

    Stoyan (Please take a moment to "Vote as Helpful" and/or "Mark as Answer" where applicable. This helps the community, keeps the forums tidy, and recognizes useful contributions. Thanks!) Blog: https://blog.pohn.ch/ Twitter: @StoyanChalakov

    Thursday, November 9, 2017 11:07 AM
  • Hello,

    What is the version of MP imported? 

    These are all the monitors that should be present under the roll-up monitor, are they healthy? Have you checked for any discoveries to be enabled?




    Thursday, November 9, 2017 11:10 AM
  • Yep, used used MP from IBM, version is 2.6

    Thursday, November 9, 2017 11:34 AM
  • All monitors except "Spectrum Virtualize Family Storage Configuration UnitMonitor" are in not monitored state
    Thursday, November 9, 2017 12:35 PM
  • Hello,

    Please open the health explorer for the device. You may wait for sometime to get it monitored after discovered. 

    You may follow the management pack guide.  You may also check whether monitors are enabled properly.


    Yan Li

    Please remember to mark the replies as answers if they help. If you have feedback for TechNet Subscriber Support, contact tnmff@microsoft.com.

    • Proposed as answer by Yan Li_ Tuesday, November 21, 2017 7:47 AM
    Friday, November 10, 2017 7:53 AM