locked
SCCM 2012 SP1 client upgrade RRS feed

 > 

  • Question

  • Question
    Sign in to vote
    0
    Sign in to vote

    After manualy pushing client installation to existing clients on some I did not get SCEP upgrade to 4.1.522 version.

    SCCM client version was upgraded but not the Antimalware Client version.

    Common for these clients are "Client Check Detail" - WMI Repository Read/Write test. Remediation failed. 0x00000130.

    Some of them do not show even Antimalware client version in Console.


    • Edited by Kaspars_ Thursday, January 10, 2013 1:28 PM mistake
    Thursday, January 10, 2013 1:22 PM

Answers

All replies

  • Question
    Sign in to vote
    0
    Sign in to vote
    See ccmeval, ccmevaltask and EndPointProtectionAgent.log on the client.

    Torsten Meringer | http://www.mssccmfaq.de

    • Marked as answer by Kaspars_ Tuesday, January 15, 2013 1:31 PM
    Thursday, January 10, 2013 1:46 PM
  • Question
    Sign in to vote
    0
    Sign in to vote

    Endpoint log have repeated lines:

    Handle EP AM policy. EndpointProtectionAgent 10.01.2013 12:57:41 9236 (0x2414)
    Firewall provider is installed. EndpointProtectionAgent 10.01.2013 12:57:41 9236 (0x2414)
    Installed firewall provider meet the requirements. EndpointProtectionAgent 10.01.2013 12:57:41 9236 (0x2414)
    Service startup notification received EndpointProtectionAgent 10.01.2013 14:56:59 11236 (0x2BE4)
    Endpoint is triggered by CCMTask Execute. EndpointProtectionAgent 10.01.2013 14:56:59 11248 (0x2BF0)
    File C:\Windows\ccmsetup\SCEPInstall.exe version is 4.1.522.0. EndpointProtectionAgent 10.01.2013 14:56:59 11248 (0x2BF0)
    EP version 2.2.903.0 is already installed. EndpointProtectionAgent 10.01.2013 14:56:59 11248 (0x2BF0)
    EP 2.2.903.0 is installed, version is lower than expected installer version 4.1.522.0. EndpointProtectionAgent 10.01.2013 14:56:59 11248 (0x2BF0)

    CCMEvaltask has (in yellow):

    Could not load logging configuration for component CcmTask. Using default values. CcmEvalTask 10.01.2013 14:56:59 11232 (0x2BE0)
    Being called due to timeout, (2) cycles time out, do nothing. CcmEvalTask 10.01.2013 15:26:59 2584 (0x0A18)

    Thursday, January 10, 2013 1:52 PM
  • Question
    Sign in to vote
    0
    Sign in to vote
    Today Remediation statuss is green. But in Endpoint protection section I can see two messages. For some computers message is "To be installed" other have "Failed, 0x8000FFF, Failed to trigger EP installer to install.
    Friday, January 11, 2013 8:10 AM
  • Question
    Sign in to vote
    0
    Sign in to vote

    Clients slowly get new SCEP 4.1.522.0

    I did nothing to them.

    Tuesday, January 15, 2013 1:31 PM