none
Found an issue rescheduling tape jobs in DPM 2010 RRS feed

  • Question

  • Scenario: Tape jobs are scheduled for today. I can see them by running a report in 'Monitoring' - 'Jobs'- 'Scheduled Tape Jobs'

    I see I have too many tape jobs all scheduled for the same time. Normally this isn't an issue, but since the jobs are so big the ones waiting will randomly fail. Had the idea of moving them to a new time slot same day.

    Selected a PG that was slated for Tape Backup, edited the time window of when it would run today. Saved changes everything confirms.

    Went back to 'Monitoring' - 'Jobs'- 'Scheduled Tape Jobs', its now missing from the list. I didn't change the day it was going to run and I didn't set the time to a value that has already expired. Job was originally scheduled for 11PM today, I set it to 5pm today instead. 

    Any explanation ?


    • Edited by Mike_Kubi Tuesday, September 1, 2015 3:39 PM
    Tuesday, September 1, 2015 3:39 PM

All replies

  • Hi,

    Sometimes it takes a while for the new schedules to show up, see what this powershell script shows.  If you modify PG again, wait about 10 minutes to re-run the script. Then it should show next run time.


    Please remember to click “Mark as Answer” on the post that helps you, and to click “Unmark as Answer” if a marked post does not actually answer your question. This can be beneficial to other community members reading the thread. Regards, Mike J. [MSFT] This posting is provided "AS IS" with no warranties, and confers no rights.

    Wednesday, September 2, 2015 11:30 PM
    Moderator