none
Windows 10 Version 1903 VS EMC Unity NAS RRS feed

  • Pregunta

  • Con la version de Windows 10 1903, no se puede conectar a la NAS una EMC Unity 350, da el error "0x80070035 The network path was not found"

    CANNOT ACCESS NAS DRIVES

    CANNOT ACCESS NETWORK ATTACHED STOREGE

    ERROR ACCESSING NAS

    Alguien ha tenido esta situación?


    Gracias

    viernes, 4 de octubre de 2019 12:08

Todas las respuestas

  • Hola, MarcoVCC:

    El error 0x80070035 se trata de un fallo conocido con varios posibles "workarounds" para facilitar la conectividad con sistemas MS w7ven. Las resoluciones más aceptadas son las señaladas por el compañero partner Umesh P:

    "
    Method 1: Run the network troubleshooter and check what it has to say.
    Make sure that Network Discovery is turned ON on the laptop, by default the Network Discovery state is off. If the Network Discovery is off, please take the following steps to turn it on.
    .- Click Start => Click Control Panel => Networking and Sharing Center.
    .- Click the Drop Down arrow next to Network Discovery => option: Turn on network discovery.
    .- Click apply.
    RSS: http://windows.microsoft.com/en-US/windows7/Enable-or-disable-network-discovery

    Method 2: No firewall or security software blocks sharing
    The issue may be caused also by your security program such an anti-virus or a Windows Firewall /Defender which might have conflicting settings as to not to perform certain tasks. I suggest that you temporary disable the anti-virus and firewall and check the result again. You would need to turn on the security programs again which you had disabled.
    RSS: http://windows.microsoft.com/en-us/windows7/Turn-Windows-Firewall-on-or-off
    RSS: http://windows.microsoft.com/en-US/windows7/Disable-antivirus-software

    Method 3: Perform system restore on your computer.
    System restore will take your computer to pervious state when it was not facing such problem, this can be done by selecting the proper restore point. To restore the operating system to an earlier point in time, follow these steps:
    .- Click Start, type system restore in the Start Search box, and then click System Restore in the Programs list.  
    .- In the System Restore dialog box, click Choose a different restore point, and then click Next.
    .- In the list of restore points, click a restore point that was created before you began to experience the issue, and then click Next.
    .- Click Finish.
    "

    ..Y otras soluciones alternativas puedes encontrarlas en el siguiente enlace, cortesía de WINDOWS10REPAIR.COM:
    RSS: Código de error: 0x80070035. La ruta de red no se encontró

     

    Desiderio Ondo || Engineer

    lunes, 7 de octubre de 2019 10:34