none
SCCM Client install-sending with winhttp failed; 80072ee7

    Question

  • I have switched over most of my servers to my new site, now I am just troubleshooting the remaining 50 or so.  I keep running into this error when trying to move some of my clients over though, none of the clients have anything in common with each other except for this error.  I don't know where to start to figure out what the issue is, there is DNS resolution and I can connect through a browser to my site from the servers in question.

    sending with winhttp failed; 80072ee7

    Tuesday, May 03, 2011 11:31 AM

Answers

  • What is 'ipconfig /all'  result on Server...does it showing proper IP address of DNS server or just 127.0.0.1 ..? if yes...correct this.
    Regards, Sachin
    • Marked as answer by Mkh1981 Tuesday, May 03, 2011 12:16 PM
    Tuesday, May 03, 2011 11:57 AM

All replies

  • sending with winhttp failed; 80072ee7

    = ERROR_INTERNET_NAME_NOT_RESOLVED so double check the name resolution.

    Torsten Meringer | http://www.mssccmfaq.de
    Tuesday, May 03, 2011 11:43 AM
    Moderator
  • I have confirmed that I have DNS resolution, going both ways to my site server, fallback status point, going both ways.  And I can connect through an internet browser to get there. 
    Tuesday, May 03, 2011 11:53 AM
  • What is 'ipconfig /all'  result on Server...does it showing proper IP address of DNS server or just 127.0.0.1 ..? if yes...correct this.
    Regards, Sachin
    • Marked as answer by Mkh1981 Tuesday, May 03, 2011 12:16 PM
    Tuesday, May 03, 2011 11:57 AM
  • Strange, but the short name works and the fqdn doesn't, I did the ipconfig /all and the server was pointing to our really old dns servers, I am guessing that was the issue, thanks for the help.
    Tuesday, May 03, 2011 12:15 PM
  • I came across below error message during SCCM 2007 R3 client push from server. When I checked the CCMSETUP.log file, I found error message:

    "Sending with winhttp failed;8002ee7"






    I convert the hexadecimal error code 80072ee7 into decimal and found that decimal error code is 12007(if you properly check the error lines shown in above pic, you can see 'Error at WinHttp SendRequest: 12007') which is "ERROR_INTERNET_NAME_NOT_RESOLVED".

    ERROR_INTERNET_NAME_NOT_RESOLVED means there is problem in DNS name resolution

    I checked IP address settings in my client. BOOM !!! I found it.Due to misconfiguration in DNS, primary IP address for DNS server was 127.0.0.1. I changed the primary IP address for DNS with actual one. After that change, client starts download the client package from server and installation completed successfully. 
    Thats it!

    Kiran Tamang

    http://sccm-admin.blogspot.in

    Sunday, February 08, 2015 8:11 AM