Windows 10 Anniversary Update breaks DHCPv6 client RRS feed

  • مناقشة عامة

  • Hi guys,

    this has been an issue from the august update and it has got a few posts in different support forums but some of the point to ask it also here, so here is the problem in short:

    After the august update windows 10 does not automatically renew or ask for IPv6 address via DHCPv6 even is RA has managed flag enabled. The only way to get an IPv6 address manually is to do ipconfig /renew6 in powershell. This works as long as the lease is valid, but after that it looses IPv6 address and you need to run ipconfig /renew6 manually again to fix it. The ipconfig command sometimes also returns with an error and you need to run it again to get an IPv6 address.

    • An error occurred while renewing interface Local Area Connection The parameter is incorrect
    • An error occurred while renewing interface Local Area Connection The semaphore timeout period has expired.
    • An error occurred while renewing interface Local Area Connection Function failed during execution.

    I will post the links to other posts after my account has been verified.

    01/جمادى الأولى/1438 10:49 ص

جميع الردود

  • Still cannot insert url to body text, but here are some links as a text to same issue in other forum posts, hopefully someone takes this seriously and alerts the right people to the issue in order to get it fixed!

    My original post

    The same problem reported by another dude

    The same problem reported again in another forum

    Hopefully this is enough reports in different forums that one of them is in the right place!
    • تم التحرير بواسطة Macrissss 01/جمادى الأولى/1438 10:56 ص added more links
    01/جمادى الأولى/1438 10:55 ص
  • I also see this. The last link in the previous post describes it very clearly.

    Even in the stateless configuration windows is not doing it correctly. With the M=0, O=1, windows is not requesting a DHCPv6 (Information-request (11)). It gets the RA, and sets the SLAAC address right. But then when the O-flag is set, it will not request the additional information from the DHCPv6. (maybe it sees the RDNSS and uses that, but the "show dnsservers" is blank.

    netsh interface ipv6 show dnsservers

    Then if you do the /renew6, I see the DHCPv6 (Information-request (11)) being sent, and the DHCPv6 replying with the DNS servers. Then the DNS servers are shown correctly in the GUI and the "show dnsserver" command.

    In a SLAAC (Stateless) setup, if the O flag is set, the Windows client should send a DHCPv6 (Information-request (11)), even if there is an RDNSS in the RA. If the O flag is not set, then of course Windows should do what it does now. Not send a Info-Req (11), and maybe use RDNSS if it chooses.

    05/جمادى الأولى/1438 12:45 ص
  • Latest update finally fixed the issue!

    • Update for Windows 10 Version 1607 for x64-based Systems (KB4013418)
    16/جمادى الثانية/1438 04:53 م
  • Was this fixed for Windows 10 Enterprise ? Our users and test machines still have the issue.

    IPCONFIG /RENEW6 Still gets a Semaphore timeout.


    • تم التحرير بواسطة VZWAlex 21/جمادى الثانية/1438 03:49 م
    21/جمادى الثانية/1438 03:47 م