locked
Hyper-V Replica Issue RRS feed

  • Question

  • Hi Everyone,

    I got one issue with Hyper-V Replica:

    From a single-host I am replicating VMs to a Cluster. So far, so good.
    After adding more Nodes to the Cluster, these can't receive the replication. One example:

    Trying to enable the replication from single-host, I get an error that the replication can't be enabled. Clicking ok and trying again and again, it will go through the cluster nodes until it finds one that is properly configured.

    Network access has been checked, local firewalls as well. Any idea regarding this behavior?

    Thanks,
    Jens


    jensit.wordpress.com

    Wednesday, September 30, 2015 9:22 PM

Answers

  • Hi Guys,

    Port 80 was not opened after adding the new nodes to the cluster.

    Thanks for your help,
    Jens


    jensit.wordpress.com

    • Marked as answer by Jens_W Friday, October 2, 2015 10:53 PM
    Friday, October 2, 2015 10:53 PM

All replies

  • Just to verify ; Did you enabled Hyper-V replica on the new nodes ?


    Regards, Samir Farhat || Datacenter Consultant || The way to share my knowledge with the community Visit my blog : buildwindows.wordpress.com

    • Proposed as answer by Alex Lv Friday, October 2, 2015 8:33 AM
    Thursday, October 1, 2015 9:42 AM
  • Hi Samir,

    Hyper-V is enabled on all nodes. They are all part of the same cluster. Each node has the firewall configured to allow inbound replication and replication enabled in Hyper-V.

    Best Regards,
    Jens


    jensit.wordpress.com

    Thursday, October 1, 2015 2:36 PM
  • Hi Jens,

    Do you see any error event logs? Can you post us the error message you get?

    -Umesh.S.K

    • Proposed as answer by Alex Lv Friday, October 2, 2015 8:33 AM
    Thursday, October 1, 2015 2:51 PM
  • Hi Jens_W,

    Please recheck your cluster replication broker replication policy related configuration is still correct, such as the authentication method , the location etc

    More information:

    Why adding Hyper-V Replica Connection Broker Fails (in Failover Cluster Manager)

    http://blogs.technet.com/b/askpfeplat/archive/2012/12/10/why-adding-hyper-v-replica-connection-broker-fails-in-failover-cluster-manager.aspx

    Deploy Hyper-V Replica

    https://technet.microsoft.com/en-us/library/jj134207.aspx

    Best Regards,


    Please remember to mark the replies as answers if they help and unmark them if they provide no help. If you have feedback for TechNet Support, contact tnmff@microsoft.com

    Friday, October 2, 2015 8:33 AM
  • Hi Guys,

    Port 80 was not opened after adding the new nodes to the cluster.

    Thanks for your help,
    Jens


    jensit.wordpress.com

    • Marked as answer by Jens_W Friday, October 2, 2015 10:53 PM
    Friday, October 2, 2015 10:53 PM